SELECTINGASITEFORTHEDUSTCOLLECTORANDLAYINGOUTAPLANFORTHEPIPING
Note: Plan, measure and mark before you drill!
Having a mapped out rough layout of your planned installation, starting from the dust collector unit at the far left and
working out to your furthest point on the right, may help simplify the installation and avoid surprises. The diagram below
shows a typical layout using all of the included piping and connectors and is intended as a reference to assist you in
planning your own layout. You may vary your layout to suit your specific shop needs and are not obliged to use all
pipes and connectors if they are not required to meet your needs. You may also prefer to temporarily assemble the
components to help you visualize your layout and the location of the hangers and their wall anchors.
The unit should be installed as close to the dust source(s) as possible and because of the location of the dust inlet port,
the dust collector must be installed to the left of the dust source(s) as shown below.
26 3/4”
18 1/8”
9”
18 1/8”
9”
18 1/8”
9”
18 1/8”
51 1/8”
Note: All dimensions are approximate. Your installation may vary - measure before drilling.
(space below provided for notes & measurements for your layout)
5
Summary of Contents for 10-030 M1
Page 23: ...1 11...
Page 24: ...1 11...
