General Monitors S4000CH, Manual

Page: 54 / 74

Model S4000CH
46
Exception: Returns an Exception Code 01 (Illegal Function) if an illegal write is requested.
Byte Function Bit Position Access
High Not Used 15 MSB Read
Not Used 14 Read
Not Used 13 Read
Not Used 12 Read
Not Used 11 Read
Not Used 10 Read
Latching/Non-
Latching
9 R/W
Energized/De-
Energized
8 R/W
Low Set point (7-0) R/W
6.8.14 Com1 Address (0Fh)
A read command returns the current address for Com1. A write command changes the
address to the requested value. Valid addresses are 1-247 decimal.
Factory default is 1.
Exception: If the address is not in range, an illegal data value (03) is returned.
6.8.15 Com1 Baud Rate (10h)
A read command returns the current baud rate for Com1. A write command changes the
baud rate to the requested values. Valid settings are shown in the table below.
Factory
default is 19,200.
Baud Rate Value Val(Hex) Access
2400 24 18 Read/Write
4800 48 30 Read/Write
9600 96 60 Read/Write
19,200 192 C0 Read/Write
Table 11: Com1 Baud Rate
Exception: If the baud rate is not in range, an illegal data value (03) is returned.
6.8.16 Com1 Data Format (11h)
A read command returns the current data format for Com1. A write command changes the
data format to the requested values. Valid settings are shown in the table below.
Default
format is 8-N-1.
Data Parity Stop Format Data(Bits 8-9) Access
8 None 1 8-N-1 0 Read/Write
8 Even 1 8-E-1 1 Read/Write
8 Odd 1 8-O-1 2 Read/Write
8 None 2 8-N-2 3 Read/Write
Table 12: Com1 Data Format
Exception: If the data format is not in range, an illegal data value (03) is returned.