MS3002 Manual v.200909
Page 21
WARNING
To avoid injury, do not connect this
miter saw to the power source until it
is completely assembled and adjusted
and you have read and understood
this Operator’s Manual.
CUTTING HEAD
(FIG. A)
WARNING
To avoid injury and damage to the
saw, transport and store the miter
saw with the cutting head locked in
the down position. Never use the stop
latch to hold the cutting head in a
down position for cutting operations.
RAISING
1. Push down slightly on the trigger
switch handle (1).
2. Pull out the hold-down latch (2).
3. Raise the cutting head to the
uppermost position.
NOTE:
This cutting head is spring
loaded.
LOCKING
When transporting or storing the miter
saw, the cutting head should always be
locked in the down position.
Fig. A
1
2
1. Push the cutting head down.
2. Press the hold-down latch (2) in to
lock.
IMPORTANT
: To avoid damage, never
carry the miter saw by the trigger switch
handle or the cutting arm.
INSTALLING THE MITER
HANDLE
(FIG. B)
1. Thread the miter handle (1) into the
hole (2) located at the front of the
miter table.
INSTALLING THE DUST BAG
(FIG. C)
1. Squeeze the metal collar wings (1) of
the dust bag (2).
Fig. B
2
1
Fig. C
2
1
3
ASSEMBLY AND ADJUSTMENT
