ATTACH THE DEPTH OF CUT ADJUSTMENT HANDLE
ATTACH THE DUST CHUTE
Attach the adjustment handle on top of the machine
as shown, using the supplied allen key and cap screw.
Install the dust chute on the rear of the machine as
shown, using the 4 supplied button head screws.
BASIC ADJUSTMENTS AND CONTROLS
CONNECTING TO A POWER SOURCE
Once the assembly steps have been completed and the unit is safely secured or installed on a work surface such
as a bench, stand or worktable, uncoil the power cord. With the switch locked-out (i.e. without the supplied safety
key
A
installed, as shown in
B
, or in the off position
C
), plug the power cord into an appropriate outlet. Refer back
to the section entitled Electrical Requirements and make sure all requirements and grounding instructions are fol-
lowed. When planing operations have been completed unplug the unit from the power source.
B
A
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG.
REPLACE DAMAGED CORD OR PLUG IMMEDIATELY.
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP, MAKE SURE THAT THE POWER SWITCH IS IN THE OFF POSITION
BEFORE CONNECTING TO A POWER SOURCE.
SWITCH OFF
C
9
HEX HEAD BOLT (1)
FLAT WASHERS (2)
LOCK WASHER (1)
HEX NUT (1)
If a permanent shop placement or installation is prac-
tical, consider using the mounting holes and drilling
matching through holes in your workbench or mount-
ing surface to bolt the planer in place (hardware not
included) on your workbench.
If you prefer an optional steel stand (item #30-006)
is available from your local General International
dealer.
