INSTALLING THE SANDER ON A STABLE SURFACE
For your convenience this sander is shipped from the
factory partially assembled and requires only minimal
assembly and set up before being put into service.
The unit should be installed on a flat, level, sturdy and
stable surface, able to support the weight of the ma-
chine and the workpiece with ease,
A
.
Never install or operate the sander over the edge of a
table, workbench or other mounting surface,
B
.
ASSEMBLY INSTRUCTIONS
BEFORE STARTING THE INSTALLATION AND ASSEMBLY, MAKE SURE THAT THE POWER SWITCH IS IN THE “OFF” POSITION AND THAT
THE POWER CORD IS UNPLUGGED. DO NOT PLUG IN OR TURN ON THE SANDER UNTIL YOU HAVE COMPLETED THE INSTALLATION
AND ASSEMBLY STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
A
B
9
INSTALLING THE DISC TABLE
1. Using 2 supplied ratchet levers and flat washers
install the disc table.
2. Adjust/level the table manually and then tighten-
the table mounting brackets
A
with a screwdriver
LEVER ON THE LEFT OF THE TABLE
LEVER ON THE RIGHT OF THE TABLE
LEVER
WASHER
1. Loosen Phillips screws as shown and remove disc
guard.
2. Prepare the surface of the disc to receive the ad-
hesive sanding disc by wiping the surface with a
rag dipped in mineral spirits or paint thinner.
(Dispose of potentially flammable solvent-soaked
rags according to manufacturer’s safety recom-
mendations.)
3. Peel the protective backing from the abrasive
paper,
A
, and stick the abrasive paper onto the
disc,
B
. Re-install disc guard.
A
B
INSTALLING THE ABRASIVE PAPER ONTO THE DISC
A
Summary of Contents for 15-142 M1
Page 19: ...RETSD Associated Assets...
