11
A
USING THE POWER SWITCH
To start the machine:
Lift the red stop panel
C
, remove
the pin
A
as shown and then push on the green start
button
B
.
To stop the machine:
Press on the red “STOP” panel
C
.
The machine can be restarted by pushing on the green
button
B
.
To lock the machine:
Lift the red “STOP” panel
C
and
insert the key
A
in the hole located behind the green
button
B
.
OVERLOAD PROTECTION/CIRCUIT BREAKER
The switch on this machine is equipped with an over-
load protection feature.
To prevent an electrical overload from damaging the
motor, in the event of a spike in line voltage or amper-
age draw, the internal overload protector will automati-
cally be tripped, thereby cutting off power to the motor.
To restart the machine, first press the reset overload but-
ton
A
located on the top of the switch box and push on
the green button .
A
B
C
TO PREVENT ANY USE OF THE MACHINE BY AN UNAUTHORIZED PERSON, IT IS RECOMMENDED TO REPLACE THE LOCK
PIN AND UNPLUG THE COLLECTOR FROM THE POWER SOURCE WHEN THE MACHINE IS NOT USED.
CHECKLIST BEFORE AND AFTER STARTING
•
Make sure you and any assistants are wearing safe and appropriate workshop attire.
• To reduce the risk of damage to the machine, as well as a potential for personal injury, after initial set-up as well
as before each use, make sure that everything is securely installed and that all fasteners and moving parts on
this machine are locked in place before starting the machine.
• Make sure the inlet mount is properly intalled, and check the inlet hose is properly connected to the dust collec-
tor and to the machine producing the dust.
•
Make sure to have on safety glasses as well as hearing & respiratory protection at all times when using the
machine.
VERIFY ALL CHECK POINTS BEFORE STARTING. FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURIES.
Summary of Contents for 10-950
Page 15: ...15 DIAGRAM ...
Page 17: ...17 NOTES ...