INSTALL ELEVATOR
INSTALL ELEVATOR
INSTALL ELEVATOR
INSTALL ELEVATOR
INSTALL RUDDER
INSTALL RUDDER
JOIN RUDDER AND FUSELAGE
JOIN RUDDER AND FUSELAGE
Install the rudder to stab with three hinges. Using
the same installation method usedon the ailerons.
1. Examine the tail of fuselage, there are two slots
for installation elevator and rudder. First, cut the
cover with knife at the tail of fuselage as shown the
next pictures.
P.3
INSTALL ELEVATOR&RUDDER PUSHRODS
INSTALL ELEVATOR&RUDDER PUSHRODS
Examine the tail of fuselage, there are four slots.
Two for elevator servo pushrods installation, the
rest for rudder servo horn.
3. Put out the elevator, cut off the covering with
knife along the line.
4. Insert the elevator to the slot again, glue the
elevator to the fuselage with epoxy.
2. Insert the elevator to the slot, make the left and
right are equal. Then drawing two lines along
the joining at fuselage and elevator.
1. Examine the tail of fuselage. There are two slots
each side you need to cut off the covering.
2. Put the rudder into the slot you just cut off. Draw
a line according to the joining at rudder and
fuselage. Then put the rudder out and cutoff the
covering along the line you drew. This procedure is
necessary cause the rudder will easy move if you do
not peel off the covering.
3. Put the rudder into the slot again. Glue it to the
fuselage with epoxy.
Insert the elevator to the fuselage. Using the same
installation method used on the rudder. Please
reference the next pictures.
C I T A B R I A - 1 2 0
C I T A B R I A - 1 2 0
