INSTALLING THE AILERONS
INSTALLING THE AILERONS
INSTALL AILERON PUSHRODS
INSTALL AILERON PUSHRODS
INSTALL AILERON SERVO
INSTALL AILERON SERVO
1. Connect aileron with wing by five hinges each
side. There are five slot on the wing and aileron.
Half hinges insert in to wings and half to aileron.
2. Test fit the ailerons to the wing with the hinges.
If the hinges does not remain centered. Stick a pin
through the middle of the hinge to hold it in position.
3.Remove any pins you may have inserted into the
hinges. Adjust the aileron so there is a small gap
between the aileron and the wing. The gap should be
small, just enough to see light through or to slip a
piece of paper through.
4.Apply six drops of thin CA to the top and bottom
of each hinge. Do not use CA accelerator. After the
CA has fully hardened, test the hinges by pulling on
the aileron.
5. Repeat this procedure for installing the right
aileron.
Do the left wing first so your work matches the
photos the first time through. You can do one wing
at a time, or work on them together.
1. Position a small nylon control horn on the aileron
positioning it as shown in the sketch and aligning it
with the servo. Mark the location fro the screw holes.
Drill through the marks you made with a drill bit.
Mount the nylon control horn to the aileron by
inserting three machine screws through the control
horn and into the nylon mounting plate on the top
of the aileron.
Pushrod wire
Pushrod wire
FasLink
FasLink
Servo horn
Servo horn
1.6mm
1.6mm
2, Locate a pushrod wire threaded on one end .
Thread a nylon clevis onto the threaded end of
the wire 20 turns. Install a silicone clevis retainer
onto the clevis. Then install the clevis on the
aileron control horn.
3. Be sure the aileron servo is centered. Enlarge
the hole in the servo arm with a Hobbico Servo
Horn Drill. Center the aileron and align the wire
pushrod with the hole in the end of the servo arm.
Using a marker, mark the location where the wire
aligns with the hole in the servo arm on that mark
a 90 bend. From the bend measure an additional
9.5mm and the cut off the excess pushrod wire.
4.Install the wire into the hole in the servo arm
using a nylon FasLink as shown in the sketch.
P.2
1. The slot for servo installation is already laser cut
you just need to cut off the covering with knife.
2. Use four sheet metal screws to attach the servo to
the wing.
3.Pull the servo wire out the root of the wing.
4. Repeat this procedure for installing the right
wing.
C I T A B R I A - 1 2 0
C I T A B R I A - 1 2 0
