Pay close attention here
Apply C.A Glue
Assemble left and right
sides the same way
Drill holes with the specified
diameter (here: 2mm)
Ensure smooth non-binding
movement while assembling
Cut off shaded portion
Apply A.B Glue
Purchase separately
2mm
A
B
P.A
C.A
1.Read through the manual before you begin, so you
will have an overall idea of what to do.
2.Check all parts. If you find any defective or missing
parts contact your local dealer. Please DRY FIT and
check for defective for all parts that will require CA
or Epoxy for final assembly. Any parts you find to be
defective after the gluing process may be difficult to
remove for warranty replacement. The manufacturer
will replace any defective parts,but will be difficult to
extend to the good parte that are good before gluing to
defective parts during assembly.
3. Symbols used throughout this instruction manual
comprise,
R
L
PART LIST------------------------------------------P.1
BEFORE YOU BEGINNING--------------------P.1
SAFETY PRECAUTION--------------------------P.1
ASSEMBLY-------------------------------------P.2-P.7
INDEX
INDEX
INDEX
INDEX
SAFETY PRECATION
SAFETY PRECATION
BEFORE YOU BEGINNING
BEFORE YOU BEGINNING
C I T A B R I A - 1 2 0
C I T A B R I A - 1 2 0
P.1
Warning!
Important Safety Precautions
#First time flyer should never fly by himself/herself.
Assistance from experienced flyer is absolutely
necessary.
#Pre-flight adjustment must be done before flying ,
it is very dangerous to fly a badly pre-adjusted
aircraft.
#Citabria is specially designed to be powered by
50cc engine, using a more powerful engine does
not mean better performance. In fact, over powered
engine may cause severe damage and injuries.
#Make sure the air field is spacious ,never fly the
plane too close to people and never get too close
to a running propeller.
#If you find wrinkles on the covering as a result of
weather changes you can use hot iron to remove
the wrinkles. Please begin with lower temperature
setting and gradually raise the temperature until
the wrinkles are gone. Too hot an iron may damage
the covering.
#Check and re-tighten up all factory assembled
screws ,use thread locker if applicable.
