Unpacking and Inspection
Installation Guidelines For 50 Hz Air-Cooled Generator Sets
13
Intake Side Panel Removal
See
. Intake side panel (A) must be removed
to access battery compartment, fuel regulator, and sedi-
ment trap.
Figure 2-6. Remove Intake Side Panel
1.
Raise lid and remove front panel.
2.
Use a 4mm hex key to remove two mounting
screws (B) and L-bracket screw (C).
3.
Lift intake panel up and away from generator set.
4.
Inspect for any hidden freight damage. Contact
freight carrier if damage is present.
NOTE:
Always lift intake side panel straight up before
pulling away from enclosure. Do not pull panel away from
enclosure before lifting up (D).
Customer Connections and Loose
Parts
See
and loose parts location.
illustrates parts
shipped loose.
Figure 2-7. Customer Connection Area and Loose
Parts Location
Rear Connections
Figure 2-8. Rear Connections
NOTE:
Generator set is equipped with a Wi-Fi module.
See Wi-Fi module owner’s manual for further instruction.
005629
B
A
C
D
005629
A
Customer electrical connection area
(behind the access panel)
B
Fuel regulator with sediment trap
C
Battery compartment (battery not supplied)
D
Positive (+) and negative (-) battery cables
E
Location of “Loose Shipped Parts”
A
Wi-Fi module
B
Main AC/Control wiring hole for 1-1/4 in conduit
C
Main AC/Control wiring hole for 3/4 in conduit
D
Fuel connection hole
A
E
C
D
B
005773
B
C
D
005774
A
