Generac Power Systems 7 kW PowerPact, Owner'S Manual

Page: 14 / 36

10 Automatic Standby Generator Owner’s Manual
3.2 — Circuit Breaker
The Main Line Circuit Breaker (MLCB) and control panel are located under the side panel cover. Open the side cover door to access both the
control panel and circuit breaker.
Figure 3-3: Control Panel / Circuit Breaker Location
Set to AUTO, the engine may crank and start at any time without warning. Such automatic starting
occurs when utility power source voltage drops below a preset level or during the normal exercise
cycle. To prevent possible injury that might be caused by such sudden starts, always set to OFF and
remove the fuse(s), disconnect the battery negative cable and shut off utility power at the MLCB
before working on or around the generator or transfer switch. Then, place a “DO NOT OPERATE” tag
on the generator panel and on the transfer switch.
NOTE: The generator is to be run with all appropriate panels in place, including during troubleshooting by a technician.
3.3 — Control Panel
Figure 3-4: Generator Control Panel and LEDs
NOTE: The control panel on this unit is intended to only be operated by qualified service personnel.
Circuit Breaker (MLCB) Control Panel
*
Operation
Mode
Buttons
and LEDs
Warning
LEDs
Alarm
LEDs