Generac 1800PSI High Pressure Washer
GENER
A
C
A
A
S
SS
SE
EM
MB
BL
L
Y
Y
7
H i g h P r e s s u r e W a s h e r
Before you connect your garden hose to the water
inlet, inspect the Inlet Screen (Figure 7). Clean the
screen if it contains debris or have it replaced if
damaged. DO NOT RUN THE PRESSURE
WASHER IF THE SCREEN IS DAMAGED.
Connect the garden hose to the water inlet. Tighten
by hand (Figure 7).
Turn ON the water.
Squeeze the trigger on the gun to purge the pump
system of air and impurities.
CAUTION: Before starting the pressure
washer, be sure you are wearing ade-
quate eye protection.
Attach the nozzle extension to the spray gun.
Tighten By Hand (Figure 8).
CHECKLIST BEFORE
STARTING ENGINE
If you have reached this point, look back over the
assembly to see if you have performed all of the fol-
lowing.
Check for properly tightened hose connections
(high pressure and water supply) and for tight con-
nections and that there are no kinks, cuts, or
damage to the high pressure hose.
Check that oil has been added to the proper level in
the engine crankcase before trying to start the pres-
sure washer.
Add the proper gasoline to fuel tank.
Provide a proper water supply (not to exceed
140°F).
Be sure to read the Safety Rules and Operation
sections before using the pressure washer.
Figure 6 — Connect high pressure hose to
pump.
Figure 5 — Connect high pressure hose
to spray gun.
Connect High Pressure
Hose Here
Figure 7 — Connect the garden hose to water
inlet and turn ON the water.
Inspect inlet
screen, do not
use if dam-
aged, clean if
dirty
Figure 8 — Connect nozzle extension to spray
gun.
High Pressure Hose
Connection
