Generac 1800PSI High Pressure Washer
A
A
S
SS
SE
EM
MB
BL
L
Y
Y
GENER
A
C
6
H i g h P r e s s u r e W a s h e r
Note:
When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF or SG rated SAE 10W30 weight.
Do Not Use SAE 10W40 Oil.
Place the pressure washer on a level surface.
Clean the area around oil fill and remove the oil dip-
stick (Figure 3).
Wipe the dipstick clean.
Insert and remove the dipstick without screwing it
into the filler neck. Check the oil level shown on the
dipstick.
If the oil level is low, fill to the edge of the oil filler
hole with the recommended oil. DO NOT OVER-
FILL.
Reinstall the oil dipstick, hand tighten securely.
Note: Check Oil Often During Engine Breakin.
Add Gasoline
DANGER! Never fill fuel tank indoors.
Never fill fuel tank when engine is run-
ning or hot. Do not smoke when filling
fuel tank.
WARNING! Never fill fuel tank completely
full. Fill tank to about 1/2" below the
bottom of the filler neck to provide space
for fuel expansion. Wipe away any fuel
spillage from engine and equipment
before starting.
The manufacturer recommends fresh, clean unleaded
regular automotive gasoline.
Use clean fuel and store in approved, clean cov-
ered containers. Use clean fill funnels. Never use
stale gasoline left over from last season or gaso-
line stored for long periods.
Clean the area around the fuel fill cap, remove the
cap (Figure 4).
Add UNLEADED regular gasoline, slowly, to fuel
tank. Use a funnel to prevent spillage.
Install the fuel cap and wipe up any spilled gasoline.
Connect Hose and Water
Supply to Pump
IMPORTANT:
You must assemble the wand and
attach all hoses before you start the engine. Starting
engine without all hoses connected and water sup-
plied will damage the pump.
Uncoil the high pressure hose and attach one end
of the hose to the base of the spray gun. (Figure 5).
Tighten by hand.
Attach the other end of the high pressure hose to
the high pressure fitting on the pump (Figure 6).
Tighten by hand.
Figure 3 — Add oil to engine crankcase. Do not
attempt to start engine without
adding oil.
Figure 4 — Add gasoline to fuel tank.
