Generac 1800PSI High Pressure Washer
GENER
A
C
10
H i g h P r e s s u r e W a s h e r
To apply detergent follow these steps:
Review the use of adjustable nozzles.
Prepare the detergent solution as required by the
job.
Hang the detergent solution on the hook of the
wireform on the handle as shown in Figure 13.
Place the small filter of the clear, detergent siphon-
ing tube into the detergent container.
Slide the adjustable nozzle forward to low pressure
mode.
Note:
Detergent cannot be applied with the nozzle in
high pressure position.
IMPORTANT:
Detergent cannot be applied without
the water source turned on.
Make sure the garden hose is connected to the
water inlet. Check that the high pressure hose is
connected to the spray gun and the pump (see
HOW TO USE YOUR PRESSURE WASHER), and
start the engine.
Apply the detergent to a dry surface, starting from
the bottom and working up.
Allow the detergent to soak in between 3-5 minutes
before washing and rinsing.
For washing, start at lower portion of area to be
washed and work upward, using long, even, over-
lapping strokes. Do not allow the detergent to dry
on. This will prevent streaking.
CAUTION: Keep the detergent siphoning
tube from coming in contact with the hot
muffler. This will damage the plastic tube.
When inserting the filter into a cleaning
agent bottle, route the tube so as to keep it
from inadvertently contacting the hot muf-
fler.
Figure 12 — Test the spray pattern.
Figure 13 — Insert the small filter into container
of cleaning solution.
