Generac Portable Products 2,400 PSI High Pressure Washer
9
If the choke was pulled to the CLOSED position to
start the engine, slowly push it to the OPEN position
as the engine runs smoother.
Engage the safety latch to the spray gun trigger
(Figure 10).
Choose the nozzle you want to use and insert it into
the nozzle extension. See How to Use the
Nozzles.
Attach the nozzle extension to the spray gun.
Tighten by hand (Figure 11).
How to Stop Pressure Washer
Move Throttle Control lever to the
Slow
position.
Wait for the engine to idle down.
Move Throttle Control lever to the
Stop
position.
Simply shutting off the engine will not release
pressure in the system.
Squeeze trigger on the
spray gun to relieve pressure in the hose
.
NOTE:
A small amount of water will squirt out when
you squeeze the trigger.
How to Use the Nozzles
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-270-1408
.
DANGER!
Never
exchange nozzles without
locking the safety latch on the trigger.
The quickconnect on the nozzle extension allows you
to switch between four different nozzles. The nozzles
vary the spray pattern, as shown in Figure 12.
Follow these instructions to change nozzles:
Engage the safety latch on the spray gun.
Pull back the collar on the quickconnect at the end
of the nozzle extension and pull the current nozzle
off. Store the nozzle in the space provided on the
handle.
Safety Latch
40° White
15° Yellow
0° Red
25° Black
Use to apply
chemical
Figure 10 Engage Safety Latch
Figure 12 Nozzle Spray Patterns
Low Pressure
High Pressure
Figure 11 Connect Nozzle Extension to Spray Gun
