Generac Portable Products 1443-0, Owner'S Manual

Page: 8 / 24

Generac Portable Products 2,500 PSI High Pressure Washer
8
• Run water through your garden hose for 30 seconds to
clean out any debris. Turn off water.
• Connect the garden hose to the water inlet. Tighten by
hand (Figure 9).
WARNING!
There MUST be at least ten feet of
unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such as a
‘Y’ shut-off connector or other convenience-type
water shut-off valve. Damage to pressure washer
resulting from disregarding this warning will not be
covered by the warranty.
• Turn ON the water and squeeze the trigger on the spray
gun to purge the pump system of air and impurities.
• Attach the nozzle extension to the spray gun. Tighten by
hand (Figure 10).
CHECKLIST BEFORE
STARTING ENGINE
Review the unit’s assembly to confirm you have performed
all of the following:
• Make sure the handle is in place and secure.
• Make sure the RED battery wire is connected.
• Check that all hose reel fasteners are tight.
• Check for properly tightened hose connections.
• Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
• Check that oil has been added to the proper level in the
engine crankcase.
• Add the proper gasoline to fuel tank.
• Provide a proper water supply (not to exceed 140°F) at
an adequate flow.
• Be sure to read “Safety Rules” and “Preparing Pressure
Washer For Use” before using the pressure washer.
Inspect inlet screen.
Do Not use if
damaged, clean if dirty.
Figure 9 — Connect Garden Hose to Water Inlet.
Figure 10 — Connect Nozzle Extension to Spray Gun.