Generac Portable Products 1443-0, Owner'S Manual

Page: 6 / 24

Generac Portable Products 2,500 PSI High Pressure Washer
6
• Secure handle to the base using the four flange nuts.
Tighten the flange nuts with a 13mm wrench. Use
caution when tightening to avoid contact with wires and
other electrical components.
• Attach the RED wire to the POSITIVE battery terminal
(see Figure 2) by aligning the yellow connector with the
terminal and pressing on firmly.
• Slowly tip the pressure washer back in place and insert
the multi–colored nozzles in the spaces provided in the
handle.
• From the rear of the unit, attach siphoning tube clip onto
the right side of the handle with the self tapping screw.
Position the self tapping screw into the pre-drilled hole
just underneath the nozzle holder frame.
• Insert the detergent siphoning tube into the clip you just
installed (Figure 3).
NOTE: When originally installed, this spring clip may be
rather stiff. Stretch the clip opening several times before
use so that the siphon filter can be more easily stored.
Assembling Hose Reel
IMPORTANT: You must take the hose off the reel when
operating your high pressure washer. The reel is for hose
storage purposes only.
• As shown in Figure 4, attach the handle to the reel with
locknuts, flat washers, and bolts. Please note that the
bolts are inserted with their heads inside the hose reel.
• As shown in Figure 5 (viewed from the front of the unit),
secure the hose reel to the handle with locknuts, clamps,
and bolts.
• Attach the spring clip with a black self tapping screw in
the hole provided on the clamp.
NOTE: There may be some hardware included with the
hose reel kit that is not used on this model.
Figure 2 — Attach RED Wire to Battery
RED Wire
Battery
POSITIVE Terminal
Do Not Detach
Figure 4 — Attach Handle to Reel
Locknut
Flat washer
Handle
Bolt
Screw
Hose Clip
Clamp
Bolt
Locknut
Hose reel
Figure 5 — Install Hose Reel on Handle
Figure 3 — Insert Detergent Siphoning Tube into Clip
Tube Clip