is needed to find the optimum placement.
The placement will affect the phase
difference between the main loudspeakers
and the subwoofer and the bass roll-off
rate.
First place the subwoofer slightly offset
from the center of the front wall. The
recommended distance to the wall is
less than 60 cm / 24" measured from the
subwoofer's driver. This position gives
increased acoustic loading (and SPL) due
to the proximity of the front wall and floor.
Cancellations from the front wall and floor
are also avoided. Front wall cancellation for
the 85 Hz high pass filtered main speakers
can be eliminated by placing them at least
110 cm / 43" away from the front wall (see
Figure 3).
If the frequency balance does not seem
right, try moving the subwoofer slightly
to the left or right so that different room
modes are excited at different levels.
Positioning the subwoofer close to a
corner will boost the bass level at lower
frequencies and may cause asymmetrical
spatial imaging.
Minimum Clearances To Walls
Or Other Objects
Do not cover the driver side of the subwoofer
or place the subwoofer so that there is less
than 10 cm (4") of free space in front of the
grille.
Make sure that the space underneath the
subwoofer is clear from obstructions. Thick
carpets may block the ventilation clearance
needed for cooling the electronics.
The reflex port side (opposite of the
connector panel side) should always have a
clearance of at least 7.5 centimeters (3") to
any objects to ensure proper functioning of
the reflex port.
Flush Mounting The
Subwoofer
If the subwoofer is flush mounted into a
wall or a cabinet, it is important to ensure
MAINS INPUT
50 / 60 Hz 150 W
100 - 240 V~
7050C ACTIVE SUBWOOFER
SERIAL
NUMBER
OUT
IN
BYPASS
ROLL-OFF
PHASE
-270°
-8 dB
-4 dB
ON
ISS
LFE +10 dB
-6
0
+3
+12
-3
LFE IN
+6
-4
INPUT dBu
PRODUCING
100 dB SPL (1 m)
ISS SENSITVITY LOW
-90°
-180°
ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT SUBJECT TO WATER OR MOISTURE. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. USE EARTHED MAINS
CONNECTION ONLY.
LAITE ON LIITETTÄVÄ
SUOJAKOSKETTIMILLA
VARUSTETTUUN PISTORASIAAN.
APPARATET MÅ TILKOPLES
JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS
TILL JORDAT UTTAG.
RISQUE DE CHOC ÉLECTRIQUE. NE PAS OUVRIR. NE PAS EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT À L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR. ADRESSER TOUTE RÉPARATION À
UN PERSONNEL QUALIFIÉ. CET APPAREIL DOIT ÊTRE RACCORDÉ À LA TERRE.
AVERTISSEMENT
WARNING
IN 1
IN 2
IN 3
IN 4
IN 5
OUT 1
OUT 2
OUT 3
OUT 4
OUT 5
THIS DEVICE COMPLIES WITH FCC PART 15 AND
CANADIAN ICES-003 RADIO FREQUENCY CLASS B
EMISSION REQUIREMENTS. REFER TO OPERATING
MANUAL FOR FULL INFORMATION.
MADE IN FINLAND
www.genelec.com
SENSITIVITY
ADJUSTMENT
LFE IN CONNECTOR
OUTPUT
CONNECTORS
BASS ROLL-OFF,
SWITCHES
PHASE,
ISS AND LFE +10 dB
MAINS CONNECTOR
MAINS SWITCH
INPUT
CONNECTORS
BYPASS SWITCH
CONNECTOR
Figure 1. 7050C's amplifier panel, connectors and controls.
Figure 3. Recommended distances to
the front wall
3
1
3
5
4
4
2
Figure 4. Examples of subwoofer posi-
tioning. 1 and 2 are good starting posi-
tions for a single subwoofer and also
work well with two linked subwoofers.
Position 3 causes a significant bass
boost and may cause asymmetric spa-
tial imaging if only one subwoofer is
used. Position 4 also works best with
two subwoofers. Flush mounting (pos.
5) generally works well.
MAINS INPUT
50 / 60 Hz 150 W
100 - 240 V~
7050C ACTIVE SUBWOOFER
SERIAL
NUMBER
OUT
IN
BYPASS
ROLL-OFF
PHASE
-270°
-8 dB
-4 dB
ON
ISS
LFE +10 dB
-6
0
+3
+12
-3
LFE IN
+6
-4
INPUT dBu
PRODUCING
100 dB SPL (1 m)
ISS SENSITVITY LOW
-90°
-180°
ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT SUBJECT TO WATER OR MOISTURE. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. USE EARTHED MAINS
CONNECTION ONLY.
LAITE ON LIITETTÄVÄ
SUOJAKOSKETTIMILLA
VARUSTETTUUN PISTORASIAAN.
APPARATET MÅ TILKOPLES
JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS
TILL JORDAT UTTAG.
RISQUE DE CHOC ÉLECTRIQUE. NE PAS OUVRIR. NE PAS EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT À L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR. ADRESSER TOUTE RÉPARATION À
UN PERSONNEL QUALIFIÉ. CET APPAREIL DOIT ÊTRE RACCORDÉ À LA TERRE.
AVERTISSEMENT
WARNING
IN 1
IN 2
IN 3
IN 4
IN 5
OUT 1
OUT 2
OUT 3
OUT 4
OUT 5
THIS DEVICE COMPLIES WITH FCC PART 15 AND
CANADIAN ICES-003 RADIO FREQUENCY CLASS B
EMISSION REQUIREMENTS. REFER TO OPERATING
MANUAL FOR FULL INFORMATION.
MADE IN FINLAND
www.genelec.com
292-8030W
WARNING: ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT
SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
USE EARTHED MAINS CONNECTION ONLY.
AVERTISSEMENT: RISQUE DE CHOC ÉLECTRIQUE. NE PAS
OUVRIR. NE PAS EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT À L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR.
ADRESSER TOUTE RÉPARATION À UN PERSONNEL QUALIFIÉ.
CET APPAREIL DOIT ÊTRE RACCORDÉ À LA TERRE.
LAITE ON LIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN
PISTORASIAAN.
APPARATET MÅ TILKOPLES JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG.
DESKTO
P1
60
Hz
-4
dB
BASS
ROLL-OF
F-
4d
B
TREBLE
TILT
-2
dB
BASS
TILT
-2
dB
-4
dB
IS
S
ON
OFF
-2
-4
-6
0
3k
BASS
TILT
1k
BASS
ROLL-OFF
DESKTOP
ALL OFF
TREBLE
TILT
Frequency (Hz)
160
20
20k
-3
-6
+2
0
+4
+6
INPUT dBu
PRODUCING
100 dB SPL (1 m)
MADE IN FINLAND
SERIAL NUMBER
This device complies with FCC Part 15 and Canadian
ICES-003 radio frequency Class B emission requirements.
Refer to operating manual for full information.
292-8030CT
ANALOG
IN
+ - GND
2
3
1
IN
MAINS INPUT
50 / 60 Hz 60 W
100 - 240 V~
8030C BI-AMPLIFIED
MONITORING SYSTEM
www.genelec.com
292-8030
W
WARNING: ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT
SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
USE EARTHED MAINS CONNECTION ONLY.
AVERTISSEMENT: RISQUE DE CHOC ÉLECTRIQUE. NE PAS
OUVRIR. NE PAS EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT À L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR.
ADRESSER TOUTE RÉPARATION À UN PERSONNEL QUALIFIÉ.
CET APPAREIL DOIT ÊTRE RACCORDÉ À LA TERRE.
LAITE ON LIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN
PISTORASIAAN.
APPARATET MÅ TILKOPLES JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG.
DESKTO
P1
60
Hz
-4
dB
BASS
ROLL-OF
F-
4d
B
TREBL
ET
IL
T-
2d
B
BAS
ST
IL
T
-2
dB
-4
dB
IS
S
ON
OFF
-2
-4
-6
0
3k
BASS
TILT
1k
BASS
ROLL-OFF
DESKTOP
ALL OFF
TREBLE
TILT
Frequency (Hz)
160
20
20k
-3
-6
+2
0
+4
+6
INPUT dBu
PRODUCING
100 dB SPL (1 m)
MADE IN FINLAND
SERIAL NUMBER
This device complies with FCC Part 15 and Canadian
ICES-003 radio frequency Class B emission requirements.
Refer to operating manual for full information.
292-8030CT
ANALOG
IN
+ - GND
2
3
1
IN
MAINS INPUT
50 / 60 Hz 60 W
100 - 240 V~
8030C BI-AMPLIFIED
MONITORING SYSTEM
www.genelec.com
LINE LEVEL SIGNAL SOURCE
Figure 2. Audio cable routing example with a two channel source shown.
Summary of Contents for 7050C
Page 1: ...Genelec 7050C Active Subwoofer Operating Manual Käyttöohje 7000 Series ...
Page 14: ......
Page 15: ......