Outdoor Router P-380
Users Guide
Figure 34 – Connected clients statistic table
Refresh
– click the button to refresh connected clients statistic information.
6.6.2 Loopback
Test
The loopback test is used for wireless link diagnostics. The loopback test graphically shows the data
transfer rate in Mb/s between the P-380 and a specified wireless network device. The transfer rate is
measured by sending an ICMP stream to the specific device. Data is refreshed every 10 seconds.
Figure 35
–
Loopback test results
To start the loopback test, do the following:
Endpoint IP
– specify the device’s IP address, whose transfer rate needs to be measured.
Start
– click to start measuring the specified wireless link.
The status line will show the last measured data transfer rate and the time when this data was
received from the wireless network device.
To stop loopback testing simply click the
Stop
button.
Gemtek Systems
Page 37
