AIR HEATER PELLET STOVE BY GEKASMETAL
Page 13
According to article 2 No. 37 of the decree of 22
nd
January 2008 regular maintenance includes interventions intended to minimize the damage of normal use, as well as
troubleshooting of accidents which induce the need for first interventions. These interventions do not alter the structure of the installation or the target of use, according to
the requirements of current technical regulations and the manual of use and maintenance provided by the constructor.
All the cleaning operations of all components should be performed when the appliance is cold and unplugged.
The product requires minimum maintenance, if certified (high quality) pellets have been used.
Daily or weekly cleaning is being performed by the user before each start up.
Clean the ashes and possible
aggregations in the “cup” that could clog
air passages.
The
“
cup
”
, in order to be cleaned properly, should be completely removed from its position and taken off the rack. Clean all the holes and the rack.
Clean and empty the ash tank daily, being careful with the hot ash. Only if the ash is completely cold you can use the vacuum cleaner to remove it.
The glass should be cleaned using a dry cloth. If needed, you can use water and a soft detergent, only if the glass is cold.
Once in a month, clean the area behind the ash tank by removing the cap
(photo).
To remove the cap, unscrew the 2 screws after you have removed the left side.
Clean with vacuum cleaner. Before operating the appliance, place back the cap.
Below you can find a summary of the necessary inspections or/and maintenance for proper function of the product.
ΤΜΗΜΑ
\
ΧΡΟΝΟΣ
DAILY
2-3 DAYS
30 DAYS
90 DAYS
YEARLY
CUP
#
ASH DRAWER
#
GLASS
#
FUME PIPES
#
CHIMNEY COMPONENTS
#
BACK ASH TANK
#
DOOR ROPE
#
CHIMNEY
#
Yearly professional maintenance is definitely suggested.
Inspection and maintenance report
After the completion of the inspection or/and maintenance activities, a report should be composed and given to the owner or his/her representative, who should confirm the
receipt in writing. The report should mention the troubleshooting, interventions performed, possible replaced or placed components, as well as possible remarks, suggestions
and requirements.
The report should be kept along with the documentation.
The inspection and maintenance report should mention the above:
Detected abnormalities which have not been restored and place the safety of the user in danger or may cause serious material damages.
Component parts which have been altered.
