5
www.geiger.de
EN
EN
5. Installation instructions
Before fixing, the strength of the masonry or of the subsurface is to be checked.
I
ATTENTION:Before the tubular motor is installed in the shaft, the
measurement from the roller end up to the centre of the carrier is to be
measured and marked on the roller.
When drilling the winding shaft
never drill into the
area of the tubular motor!
When inserting into the shaft, the tubular motor
must
not be struck and must not be allowed to
fall into the shaft.
GEIGER connector system:
Connection of limit stop and short motor:
1. Snap suitable tubular adapter onto the short
motor.
2. In the case of MODUALRline Easy* (GR45..E01),
the magnetic shaft M45B033 must additionally be
inserted into the short motor (see figure).
Disconnection of limit stop and short motor:
1. The drive
must first be disconnected from the
mains.
2. Twist the unlocking lever with a 5 mm hexagon
socket key.
3. The short motor can then be removed simply
from the limit stop.
Installation into the rolling shutter:
Fix motor support to available stud bolts or in the
side frame.
Insert motor into the shaft with a suitable adapter
and drive up to the stop of the shaft adapter.
Insert roller capsule on the opposite side.
Clip shaft with motor to motor support.
On the opposite side pull out roller capsule until
bolt fits into ball bearing.
Screw together roller capsule with shaft.
Screw together shaft with tubular carrier.
Fix roller shutter casing to shaft.
* The magnetic shaft M45B033 must be installed into the motor with all electronic
and radio controlled limit stops such as GEIGER Easy (GR45..E01), GEIGER
SoftPerfection (GR45..E03), GEIGER SoftPerfection-S (GR45..E04) and GEIGER
VariousWireless (GR45..F01).
unlocking
lever
tubular
adapter