Gehl SL3635, Operator'S Manual

Page: 60 / 82

Electrical System
Problem Possible Cause Remedy
Starter will not
engage when key
is turned to
START
.
Seat or restraint bar switch
malfunctioning or not
activated.
Poor connections to starter
relay in instrument panel.
Battery terminals or cables
loose or corroded.
Faulty starter relay in
instrument panel.
Battery discharged or
defective.
Starter solenoid not
functioning.
Ignition wiring, seat switch,
restraint bar switch, etc.
loose or disconnected.
Starter or pinion faulty.
Replace switches as needed.
If engine still doesn’t start,
contact your dealer.
Verify relay connections.
Clean terminals, cables and
retighten.
Contact your dealer.
Recharge or replace battery.
Troubleshoot circuit. Replace
the starter solenoid.
Check wiring for poor
connections, broken leads;
repair wiring or connection.
Remove starter;
repair/replace as needed.
Work lights not
functioning
properly.
Single light doesn’t work:
Light bulb burned out, faulty
wiring.
No lights at all; 15 ampere
breaker tripped.
Faulty light switch or poor
ground.
Check and replace light bulb
as needed. Check wiring
connection to light.
Check circuit and locate
trouble before replacing fuse.
Replace light switch. Check
ground wire connections.
Lift/Tilt and/or
drive lock
solenoids do not
work.
Wiring to solenoids
disconnected or faulty.
Faulty seat or restraint bar
switch.
Faulty solenoid valve coil.
Faulty hydraulic solenoid
relay in instrument panel.
Troubleshoot circuit, repair.
Contact your dealer.
Contact your dealer.
Contact your dealer.
57 908268/BP0904