Gehl SL3635, Operator'S Manual

Page: 50 / 82

Note:
Gehl does not recommend cleaning the outer element.
4. Use a trouble light inside the outer element to inspect for spots, pinholes
or ruptures. Replace the outer element if any damage is noted. The outer
element must be replaced if it is oil- or soot-laden.
Inner Element
Note:
Replace the inner element only if it is dirty or if the outer element has been
replaced three times.
1.
Before removing the inner element from the housing, clean out any dirt
built up in the housing. Leave the inner element installed during this step
to prevent debris from entering the engine intake manifold. Remove the
inner element.
Reinstallation
1.
Check the inside of the housing for any damage that may interfere with
the elements.
2.
Be sure that the element sealing surfaces are clean.
3. Insert the element(s), making sure that they are seated properly.
4.
Secure the cover to the housing with the two clamps.
5. Check the hose connections and make sure they are all clamped and
tightened properly.
6. Reset the indicator by pressing the reset button.
Engine Service
Check Engine Mounting Hardware
All bolts that secure the engine mounting brackets to the engine and the
loader frame should be checked and re-tightened as necessary.
Allow hot engine and hydraulic system components
to cool before servicing.
Check Engine Oil Level
Important: For new units, the initial oil
change should be after the first 50 hours.
Open the rear door and engine access
cover. Pull out the dipstick and check the
oil level. Markings on the dipstick
represent
FULL
and
LOW
(add oil) levels.
47 908268/BP0904
WARNING
Fig. 29: Oil Dipstick and Fill Cap
1. Oil Dipstick
2. Oil Fill Cap
2
1