page | 23
RS-232 and IP Configuration
IP / UDP Configuration
The 6x2 Matrix for HDMI 4K x 2K supports IP-based control using Telnet, UDP, or the built-
in Web-based GUI. To set up IP control, the network settings for the 6x2 Matrix for HDMI
4K x 2K must be configured via RS-232. The default network settings for the matrix are as
follows:
Description
IP Address / Port
Description
IP Address / Port
IP Address
192.168.1.72
UDP Port
23
Subnet
255.255.255.0
Local UDP Port
50007
Gateway
192.168.1.254
Remote UDP IP
192.168.1.255
HTTP Port
80
Remote UDP Port
50008
1.
Connect an RS-232 cable from the PC to the 6x2 Matrix for HDMI 4K x 2K.
Also make sure that an Ethernet cable is connected between the matrix and the
network.
2.
Launch a terminal emulation program (e.g. HyperTerminal) and use the RS-232
settings listed on the previous page.
3.
Set the IP address for the matrix using the
#sipadd
command.
4.
Set the subnet mask using the
#snetmask
command.
5.
Set the gateway (router) IP address using the
#sgateway
command.
6.
Set the Telnet listening port using the
#set_telnet_port
command.
7.
Set the HTTP listening port using the
#set_http_port
command.
8.
Set the UDP remote IP address for the matrix using the
#set_udp_remote_ip
command.
9.
Set the UDP listening port for the matrix using the
#set_udp_port
command.
10.
Set the UDP remote port for the matrix using the
#set_udp_remote_port
command.
11. Reboot the matrix to apply all changes, then type the IP address that was
specified in step 3, in a Web browser to access the Web GUI. Use the same IP
address to Telnet to the matrix.
NOTE:
Depending upon the network, all related IP, Telnet, and
UDP settings will need to be assigned. Consult your network
administrator to obtain the proper settings.
Advanced Operation
