Before setting
unicast
mode, it is important to identify the RS-232 device in the system
with which the computer will be communicating. We will use the same setup as before.
However, this time we wish to talk to the RS-232 device connected to the Receiver unit
(highlighted in yellow).
5. Quickly press and release the EDID button on the Receiver unit to obtain its information.
From the example above, we need to know the ID of the Receiver and where it is located
within the system in order to communicate with it. In this case, the Receiver we want to
talk to is “4 0 3” (ID + Depth). This value is specified as part of the command line.
6. Type the following at the
boot#
prompt:
socat5 u 115200 19200 4 0 3
OPERATING THE DAISY CHAIN HD SYSTEM
V008.01
ID: 4 0 DEPTH: 3
HD Audio
Host exit socat5 Temporarily
Receiver
Sender
to Hi-Def source
RS-232 controller
(Computer)
Splitter
Display
RS-232 device
(GTV-AUDDEC-N)
RS-232 device
(GTV-AUDDEC-N)
Display
GTV
-AUDDEC-N
GTV
-AUDDEC-N
Summary of Contents for GTB-HD-DCR
Page 1: ... Daisy Chain HD System GTB HD DCS GTB HD DCRP GTB HD DCR User Manual ...
Page 5: ...Sender Unit Layout INTRODUCTION 7 4 3 5 6 1 2 Back Front Top ...
Page 7: ...Splitter Unit Layout INTRODUCTION 7 6 4 3 5 1 2 Top Front Back ...
Page 9: ...Receiver Unit Layout INTRODUCTION 8 4 3 5 7 6 2 1 Front Top Back ...
