25
c. Interface with Gefen Syner-G™ via RS-232 ports of Sender and Receiver.:
1. Direct interface with the Sender: Connect RS-232 Tx, Rx, and Ground from a computer
with a Serial (RS-232 port), or using a USB-to-RS-232 adaptor, to the removable 4-pin
“Captive Screw” Phoenix connector that is attached to the
RS-232 port of the Sender
unit. Please note that the upper pin is not used (marked as
No Connection). Each of the
remaining 3 pins is identified on the connector panel.
If the Sender was configured to
be in “Remote-End-Control” mode (see section (b) on previous page), return it to its
default mode by following step (2) of section (b).
2. Direct interface with the Receiver: Since the Receiver does not have any customizable
features , it cannot be used with Gefen Syner-G™.
3. Interface with the Sender by connecting through the Receiver:
i.
Place the Sender unit in “Remote-End-Control” mode (see section (b) on previous
page for details). Wire the Sender unit as needed and install it in its location.
ii. Make sure that the 3 position slide switch on the front panel of the Receiver is set to
RS-232 Pass-Thru mode.
iii. Connect RS-232 Tx, Rx, and Ground from a computer with a Serial (RS-232 port),
or using a USB-to-RS-232 adaptor, to the removable 3-pin “Captive Screw” Phoenix
connector that is attached to the
RS-232 port of the Receiver unit.
Please note that The Sender and Receiver’s Tx, Rx, and Ground pin-outs for their Phoe-
nix connectors are different. To ensure proper operation, please follow the pin-out of
each connector as printed on each unit’s enclosure.
RS-232
Summary of Contents for EXT-UHDA-HBTL-RX
Page 26: ...26 RS 232 RS 232 Commands EXT UHDV WP HBTLS TX ...
Page 27: ...27 RS 232 ...
