Geeetech 3D WiFi, User Manual

Page: 45 / 48

43
USB and WiFi indicator will flash rapidly for 15 seconds to make upgrading before jumping
to application program. (The initial status of the application program is its two indicators
flash asynchronously and slowly). If the indicators flash slowly and simultaneously, it
indicates an exception occurred during the upgrading process.
d. During upgrading, if the voltage is unstable or there is blackout, it will lead to
upgrading failure. Moreover, there will be no upgrades after recharging. It needs to re-copy
the folder or modify the configure file to make upgrading.
7. FAQ
Q1: How to enter the configuration mode and reset mode?
A: Press "set" with a pin, you will find the Wi-Fi indicator light gets dim and then flickers
fast. At this moment
，
it is in Configuration mode. Keep pressing and the light will flicker
slowly to enter the reset mode.
Q2 :When I press "stop" on my Easy Print 3D APP
，
the printer does not stop immediately
，
Why?
A:There is a program cache. When you press "stop", the next instruction is stopped. But the
printer will not stop until it run current instruction fully. An instruction may contain many
moves.
Q3: Wi-Fi connection is failed. How to solve it?
A: Make sure the 3D WiFi Module is in a good internet condition. Then go into configuration
mode and choose the Wi-Fi hotspot with the strongest signal.
Q4: Unable to find the―GT_printer‖ hotspot.
A: Make sure 3D WiFi module is in the config. mode in which the three indicator lights are
constantly on. Please follow Step 2 >―Wi-Fi configuration‖.
Besides, please keep your phone near the 3D WiFi module.