Page 12 (Revision 1.0) Copyright © 2018 GeeTramp® All Rights Reserved.
JUMPING MAT & SAFETY PAD WITH PROTECTION BARRIER
The following is provided as a reference for any future maintenance.
Warning: Before attaching any springs
read “How t
o Use the Spring
Tool” i
nstructions in step 2.
Fitting the mat and pad assembly.
Step 3.1
Lay out the jumping mat inside the frame, then
attach the corner springs as per diagrams to the left.
When installing springs, be mindful to keep the
tension on the mat balanced. Do this by installing the
next spring on the opposite side of the frame. Then
follow the sequence shown for assembling the rest
of the corner springs
.
Note: Only complete the corner springs at this stage
Step 3.2
You should now have the jumping mat attached to
the frame with just the corner springs in place.
Lay your safety pads out on top of the mat.
Underneath the pads,
there’
s a protection barrier.
Starting next to the previously installed springs, slide
the material over each spring V rings as per the
diagram to the left.
Note: This does not apply to the corner springs that
attach to the round corner ring that were installed
during Step 3.1.