Page 10 (Revision 1.0) Copyright © 2018 GeeTramp® All Rights Reserved.
ASSEMBLY
The Mini Trampoline comes 95% pre-assembled.
Basically, the legs need to be set and pinned to the leg angle desired prior to use.
Step 1.0
Remove Mini Tramp (ref #1) from its packaging.
Lay Mini Tramp upside down on a suitable surface to
protect the mat and pads from sharp objects (e.g. on a
layer of cardboard or carpet etc.)
Step 1.1
Fold out one leg assembly, adjust the legs to the desired
position (see Maximum Weight of the User), line up the
adjustment holes in the inner and outer tubes. Install a
lock pin (ref #3) on the upper and lower sections. Repeat
for the other leg assembly.
This is an example of the entry side leg assembly in the
lowest setting, with the lock pins installed.
Step 1.2
Ensure the rubber feet are rotated on the frame so they
are all level with the ground
Step 1.3
Ensure the rubber feet are located properly in the
depressed ring on the leg frame. This ensures the rubber
feet remain wide apart for maximum stability.
Warning:
If the rubber feet become dislodged and slide towards the centre area, then the Mini
Tramp will become unstable with a high risk of tipping over when being jumped on.