20
Programming the Y Series
using the keypad
Although every Y Series
spa pack is factory set,
in certain cases when
servicing or replacing a
new unit in the field,
it may be necessary to set
a new pre-determined
low-level program
configuration into
the spa pack
Follow these simple steps
to re-enter the low-level
programming menu using
the keypad:
Press and hold the
Pump 1
key for 30 seconds
98
Use the
Up/Down
key to
choose the new desired
low-level configuration
number and press the
Program
key to confirm
the selected configuration
If the
Program
key is not
pressed within 25 seconds,
the unit will exit this menu
without changing any
settings
Note: If the keypad in use
does not have the Program
key, use the
Ligh
t key instead.
The keypad display will
show
L xx
where
"xx"
represents the previous
configuration number
registered in the system
At power-up the spa pack
will upload all the different
configurations from the
instik memory
The unit will then enter
the low-level configuration
menu
The keypad display will
show
L xx
where "
xx
"
represents the previous
configuration number
registered in the system
Use the
Up
/
Down
key to
choose the new desired
low-level configuration
number
Press the
Prog
key to
confirm the selected
configuration
If the
Prog
key is not
pressed within 25 seconds,
the unit will exit this menu
without changing any
settings
Note: If the keypad in use
does not have the Prog key,
use Light key instead.
Note: When programming is
finished, do not forget to turn
power off, remove the in.stik,
and re-install the pack’s cover.
Programming the Y Series
using the in.stik
Follow these simple
steps to upload new
pre-determined low-level
program configurations
into the spa pack
Shut electrical power off
Remove the cover to
access the low-voltage
inlink connectors inside,
connect the instik to the
communications port
(see figure), and then
re-apply power to pack
Programming the Y Series
communications port
