8
Program menu
The program menu is accessible by holding down the
Light
key for 5 seconds� In the program menu the following
parameters can be set: clock, filter or purge cycles, economy
mode and temperature units� While in the program menu,
use the
Up
or
Down
key to adjust the parameters and use
the
Light
key to jump to the next parameter� The changes will
be saved after the confirmation of the last parameter only�
If there is no action taken for 10 seconds, the system will exit
the program menu without saving any changes�
Setting the clock
Enter the program menu by holding down the
Light
key
for 5 seconds� The display will show the current clock setting
with the hour flashing�
Depending on factory settings your system may be set
to 24-hour time or 12-hour time�
Setting the hour: Use the arrow keys to adjust the hour� Press
the
Light
key to jump to the next parameter, the minutes�
Setting the minutes: Use the arrow keys to adjust the
minutes� Press the
Light
key to jump to the next parameter,
the filter or purge start time (FS)�
Programming the filter/ purge cycles
Depending on system configuration your spa will
perform either a filter or a purge cycle� The filter cycle
menu consists of the following parameters: the start time
(FS), the duration (Fd) and the frequency (FF)� The purge
cycle menu consists of the following parameters: the start
time (FS) and the frequency (FF)�
A filter cycle consists of starting all the pumps and blower
in high speed for 1 minute (purge step) then, the pump
associated with the filter will run in low speed for the
remaining duration of the filter cycle (clean step)�
A purge cycle is used when the spa is equipped with a
24 hour circulation pump which provides a continuous
clean step� It consists of starting all the pumps and blower
in high speed for 1 minute�
Programming steps
