7
Start or stop accessories
To start or stop an accessory, press the associated button�
Indicators will light up when the associated accessory is on�
When an accessory has more than two states, press the
button until it reaches the desired state� Indicators will
flash when dual speed pumps are on at low speed, and
will be solid at high speed�
If you have a blower it will be controlled by the
Pump 2
key� The order of actions is as follows: pump 2 on;
pump 2 high speed (if applicable); blower on;
pump 2 off; blower off�
Keypad functions
Water temperature
The temperature shown on screen is the current water
temperature� Use the
Up
and
Down
buttons to set
the desired temperature�
The set point icon will appear at the top of
the screen� After 3 seconds without any change to
the set temperature value, the keypad will resume
the normal display�
Off Mode
Pressing Pump 1 for 5 seconds will enable the Off mode�
This mode allows you to stop all outputs including
automatic functions such as filter cycle, heat request
and smart winter mode for 30 minutes to perform quick
spa maintenance� When Off mode is active, the display
will toggle between the “OFF” message, the clock and
the water temperature� The spa light will flash for a few
seconds before the end of the 30 minutes to warn you that
the system is about to resume its normal operation� Press
Pump 1 or Pump 2 (if available) to restart the system
before the expiration of the 30 minute delay� When the
system resumes its normal operation, the display shows
“On“ for 3 seconds�
