8
Start or stop accessories
To start or stop an accessory, press the associated button� Indicators will light up when the associated accessory is on�
When an accessory has more than two states, press the button until it reaches the desired state� Indicators will
flash when dual speed pumps are on at low speed, and will be solid at high speed�
If you have a blower it will be controlled by the
Pump 2
key� The order of actions is as follows: pump 2 on;
pump 2 high speed (if applicable); blower on; pump 2 off; blower off�
Keypad functions
Water temperature
The temperature shown on screen is the current water
temperature� Use the
Up
and
Down
buttons to set
the desired temperature�
The set point icon will appear at the top of the screen�
After 3 seconds without any change to the set temperature
value, the keypad will resume the normal display�
Off Mode
Pressing Pump 1 for 5 seconds will enable the Off mode�
This mode allows you to stop all outputs including
automatic functions such as filter cycle, heat request and
smart winter mode for 30 minutes to perform quick spa
maintenance� When Off mode is active, the display will
toggle between the “OFF” message, the clock and the
water temperature� Press Pump 1 or Pump 2 (if available)
to restart the system before the expiration of the 30 minute
delay� When the system resumes its normal operation, the
display shows “On“ for 3 seconds�
Keypad Lock
(Available only if the lock feature is enabled in the spa
controller configuration)
You can lock the keypad by selecting one of 2 security
levels:
Partial
or
Full
� The
Partial
level locks the set
point adjustment and many options in the settings menu�
The
Full
level locks all keypad functions�
Partial lock activation
Press both arrow keys simultaneously for 5 seconds�
The keypad will display "LocP"� Release both keys to
engage
Partial
lock�
Full lock activation
Press both arrow keys simultaneously for 5 seconds�
The keypad will display "LocP"� Keep pressing both arrow
keys for 5 more seconds (10 seconds total)� The keypad
will display "LocF"� Release both keys to engage
Full
lock�
To unlock the keypad (either
Partial
or
Full
), press and
hold both arrow keys for 5 seconds; the "uLoc" message
will be displayed for a few seconds as a confirmation�
