11
Setting filter or purge cycle start time
The display will show FSxx, “xx” representing the starting
hour of the cycle� Use the arrow keys to adjust the hours�
Use the
Program
key to jump to the next parameter,
filter duration (Fd)�
Setting filter or purge cycle frequency
The display will show FFxx, “xx” representing the number of
cycles per day� Use the arrow keys to adjust the frequency�
Use the
Program
key to jump to the next parameter,
economy mode (EP)�
The “Filter” indicator lights up when filter is on
and flashes when suspended�
Setting filter cycle duration
(not available on purge systems)
The display will show Fdxx, “xx” representing the duration
in hours of the filter cycle� Use the arrow keys to adjust
the duration� Use the
Program
key to jump to the next
parameter, filter or purge frequency (FF)�
0 = no filtration
24 = continuous filtration
It is not recommended to set this to "0"�
Programming steps
Setting economy mode*
This mode allows you to lower the temperature set point of
the spa by 20 °F (11 °C) during a certain period of the day�
The display will show EPx, “x” representing the state of
the programmed economy (0 = disabled, 1 = enabled)�
Use the arrow keys to enable or disable economy mode�
Use the
Program
key to jump to the next parameter,
economy start time (ES)� When the Economy mode is ON,
the display will toggle between the “Eco” message, the
time, and the water temperature�
* Note that the parameters for the economy mode settings are associated to specific low level configuration of the system that are not
present in all software revisions.
