GeBe 570752, Manual

Page: 22 / 28

22
English English
ENGINE OIL CHANGE
Drain the oil while the engine is warm to ensure
complete and rapid draining.
1. Remove the oil dipstick and drain plug to drain the
oil.
2. Reinstall the drain plug, then tighten the plug
securely.
3. Refill oil and check the oil level.
Oil capacity: 2,2 kW 0,55 l.
5,5 kW/6,5 kW 1,10 l.
8,5 kW 1,20 l.
CAUTION
Used engine oil may cause skin cancer if repeatedly
left in contact with the skin for prolonged periods.
Although this is unlikely unless you handle used oil
on a daily basis, it is still advisable to thoroughly
wash your hands with soap and water as soon as
possible after handling used oil.
Please dispose of used engine oil in a manner that is
compatible with the environment. We suggest you
take use a sealed container to take it to your local
service station or recycling center for reclamation.
Do not throw it in the trash or pour it on the ground.
AIR CLEANER SERVICE
A dirty air cleaner will restrict air flow into the
carburetor. To prevent carburetor malfunction,
service the air cleaner regularly. Service more
frequently when operating the generator in
extremely dusty areas.
CAUTION
Using gasoline or flammable solvent to clean the
filter element can cause a fire or explosion. Use only
soapy water or a nonflammable solvent.
NOTICE
Never run the generator without the air cleaner.
If not, rapid engine wear will result.
1. Open the air cleaner clip and open the air cover.
Check the air cleaner element to see if it’s
complete and clean.
2. If the air cleaner element is dirt, please clean
it: Wash the air cleaner element in a solution of
household detergent and warm water, then rinse
thoroughly or wash in nonflammable or high flash
point solvent. Drop a few points engine oil in,
then, squeeze out.
3. Reinstall the air cleaner element and the cover.
FUEL SEDIMENT CUP CLEANING
1. Turn the fuel valve to the OFF position. Remove
the sediment cup, o-ring and strainer according to
the arrow direction.
2. Clean the sediment cup, and o-ring, and strainer
in nonflammable or high flash point solvent.
3. Reinstall the o-ring, and strainer and screw back
the sediment cup.
4. Turn the fuel valve ON and check for leaks.
SPARK PLUG SERVICE
Recommended spark plugs: F7RTC or other
equivalents.
1. Remove the spark plug cap.
2. Use the plug wrench to remove the spark plug.
3. Visually inspect the spark plug to see if the
insulator is cracked, if so, replace it with a new the
spark plug.
4. Measure the plug gap with a feeler gauge. Correct
as necessary by carefully bending the side
electrode. The gap should be: 0.70-0.80 mm.
5. Check the spark plug washer to see if it’s good.
6. Reinstall the spark plug, tighten it with the plug
wrench and impact the washer. Reinstall the spark
plug cap accurately.
Please use the spark plug in a suitable heat range.
STORAGE
WARNING
In order to avoid burning or five due to contact with
any hot part of the generator, don’t pack and store
the generator before it is cooled. If it’s need be
stored for a long time, be sure the storage area is
clean and dry.
1. Drain the fuel in the fuel tank out, clean strainer,
o-ring and sediment, then refit them well. Drain
fuel out of the carburetor by loosening the drain
bolt, then refit it and screw the carburetor bolt
tight.