Gear4 espresso, Quick Start Manual

Page: 3 / 46

User Manual | Espresso | GEAR4 3
WARNING
To reduce the risk of fire or electric shock, do not
expose this unit to rain or moisture.
The apparatus shall not be exposed to dripping or
splashing and that no objects filled with liquids, such
as vases, shall be placed on the apparatus.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
CAUTION
Use of controls or adjustments of performance or
procedures other than those specified may result
in hazardous radiation exposure.
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or the like.
UNPACKING AND INSTALLATION
Unpack your unit carefully. We recommend that
yousave the packaging in case you ever need
to store your unit. To avoid damage, never place
the unit or its batteries near radiators, in front of
heating vents, under direct sunlight or near water.
FOR YOUR SAFETY
‒ Never handle the unit with wet hands, as this
could cause fire or electric shock.
‒ Refer servicing to qualified personnel only.
‒ Do not open the housing.
‒ Unplug the unit during lightning storms and
when unused for extended periods of time.
DISPOSAL
According to the European Directive 2002 / 96 /
EC all electrical and electronic products must be
collected separately by a local collection system.
Please act according to your local rules and do
not dispose of your old products with your normal
household waste.
Do not dispose of batteries with your normal
household waste. Follow local regulations for
safe disposal.
The wheeled bin mark indicates that
this product should not be disposed
with other household waste throughout
the EU. To prevent possible harm to the
environment or human health from
uncontrolled waste disposal, recycle it
responsibly to promote the sustainable
reuse of material resources. To return
your used device, please use the return
and collection systems or contact the
retailer where the product was
purchased. They can take this product
for environmental safe recycling.
WARNING
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert user to the presence
of uninsulated ‘Dangerous Voltage’
within the product’s enclosure that may
be of sufficient magnitude to constitute
risk of electric shock to person.
WARNING
The exclamation point within an
equilateral triangle is intended to alert
user to the presence of important
operating and maintenance (servicing)
instruction in the literature
accompanying the appliance.
CAUTION
RISK OF ELECTRIC SHOCK: DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
FCC RULES
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate this
equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
‒ Reorient or relocate the receiving antenna.
‒ Increase the separation between the equipment
and receiver.
‒ Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
‒ Consult the dealer or an experienced radio/TV
technician for help.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm
between the radiator and your body.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference,
and
2) This device must accept any interference
received, including interference that may cause
undesired operation.
INDUSTRY CANADA
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved
for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than necessary for successful
communication.
This Class B digital apparatus complies with
Canadian ICES-003.