Gear Lite ADC-9033, User Manual, Page: 14 / 32

13 • Setup (Iss. 04)
Status and Selection LEDs
The front edge of the ADC-9033 has four LED indicators that display the status
of the input signals, and indicate menu function and selections. (
Figure 6 )
Figure 6 ADC-9033 Front Edge Status Indicator LEDs
Table 1 describes the status LEDs available on the ADC-9033.
Table 1 Status LED Descriptions
LED Color Function
OK
Green
When lit, this LED indicates that a valid
a
input signal is
present and no anomalies have been detected. The
ADC-9033 is functioning correctly.
ERROR
Flashing
Red
When flashing, this LED indicates when the color sync is
not locked either due to an absence of a color signal or
an incorrect video standard setting. Applies to composite
and Y/C formats.
Red
When this lit, this LED indicates that an invalid
a
signal
has been detected, or no input is present on the input.
The SDI output is muted.
DOWN
b
Flashing
Yellow
When lit, this LED indicates the menu item range is
greater than the lower limit, but equal to or less than
unity.
Yellow
When flashing, this LED indicates that the selected menu
item is adjusted to the lower limit.
Off
When unlit, this LED indicates the selected menu item is
adjusted above unity.
UP
b
Yellow
When lit, this LED indicates that the menu item range is
less than the upper limit, but equal to or greater than
unity.
Flashing
Yellow When flashing, this LED indicates that the selected menu
item is adjusted to the upper limit.
Off
When unlit, this LED indicates that the selected menu
item is adjusted below unity.
OK LED UP LED DOWN LED
ERROR LED
012
34
56
789AB
C
D
E