Gear Lite ADC-9033, User Manual, Page: 13 / 32

Setup (Iss. 04) • 12
Setup
Power Adapter and Supply
Connect the PS-9000 power adaptor to the power supply connector. The
PS-9000 provides up to 2A of reg5V DC (5%). The DC power cord has
a locking connector that securely fastens into the power supply DC jack on the
ADC-9033. The ADC-9033 has a standard miniature power jack (center pin
positive).
If using an adaptor other than the PS-9000, ensure that:
• the polarity is correct
• the voltage is +5V DC regulated to 5%
• sufficient current for the ADC-9033 is supplied
Caution
— Use of improper adaptors may damage the ADC-9033
and will void the warranty.
Installations outside of North America using line voltages of 200-240V require a
plug, certified for the country of use, to be installed on the supplied line cord.
Refer to the section “
Important Regulatory and Safety Notices to Service
Personnel ” at the front of this manual for details.
Cable Connections Overview
Connect the cables to the ADC-9033 according to the designations indicated on
the chassis label and
Figure 5 . The input is internally terminated at 75ohm. It is
not necessary to terminate unused outputs.
Figure 5 ADC-9033 Connections
POWER
SUPPLY
CVBS/Y/Y/G IN U/B IN SDI OUT 2 SDI OUT 4
C/V/R IN SDI OUT 1 SDI OUT 3