– 37 –
'DVKHGOLQHVLQGLFDWHOLJKWXVHGRQVRPHPRGHOV
6HUYLFH0RGH7HVW0DWUL[
.H\3UHVVHG
$FWLYDWHV
7LPH
6WHDP
0DLQ3XPS
PLQ
$GGHG+HDW
$X[LOLDU\3XPS
0LQ
6HOHFW&\FOH
+HDWHG'U\
7RJHWKHUIRU
VHFV
'HWHUJHQW5LQVH$LG0RGXOH
0LQ
+HDWHG'U\
:DWHU9DOYH
0LQ
'HOD\+RXUV
+HDWHU
0LQ
+HDWHG'U\
'HOD\+RXUV
7RJHWKHUIRU
VHFV
6HWVDXWR)(QWU\)ODJLQWKH
((3520VRDWQH[WSRZHUXS
WKHFRQWUROZLOODXWRPDWLFDOO\
HQWHU)DFWRU\7HVW0RGH
&RQWUROVHWVDXWR)%LW&RQWUROWKHQWXUQVWKH
FDOURGDOO/('VDQGEHHSHU21IRUVHFWXUQWKH
FDOURGDOO/('VDQGEHHSHU2))IRUVHFWXUQWKH
FDOURGDOO/('VDQGEHHSHU21IRUVHFWXUQWKH
FDOURGDOO/('VDQGEHHSHU2))
Top Control Models
Service Mode Control Operation:
When a control is activated in the service mode, the output will continue to remain active until the maximum
time has expired or another keypad is pressed. Once the water valve is activated, the microprocessor must
perform a drain cycle to pump out the water before exiting the service mode.
Fast Control Model Reset:
Initiate a fast control model reset before replacing a nonresponsive control unit.
To initiate a fast control model reset:
• Make sure the unit is powered off.
• Press and hold the Start/Reset keypad and power the unit on. Continue holding the Start/Reset keypad
for 2 seconds after powering the unit on.
• Wait 5 seconds, then power the unit off.
• Wait another 5 seconds, then power the unit back on.
Control Replacement/Calibration:
The dishwasher will enter into the test/00 calibration mode when the unit is fi rst powered on. The door
must be closed and latched. Wait approximately 6 minutes for the second fi ll before canceling the cycle by
pressing the Start/Reset pad. The dishwasher will be ready to operate after the pump out.
