4
INSTALLATION INSTRUCTIONS
(continued)
6.
Strip 13 mm (1/2
″
) of the insulation from the
wires. Connect the white to white, black to
black and green to the prepared hole with the
green ground screw provided.
7.
Replace the wiring box cover and screw.
Make sure that all wiring is safely contained
inside.
8.
Install the light (75 watt maximum). For
easier installation, squeeze the plastic lens
and remove it from the hood. Remember
to reinstall the lens.
9.
Turn on the power and check the operation
of the fan and light.
INSTALL THE RANGE HOOD
WARNING: Turn off the proper circuit at the
service entrance before wiring this range hood.
1.
Run electrical wiring through the hole drilled in
the wall or cabinet. Split wiring for 15.2 cm (6
″
)
and install the proper connector for the type
of wire used.
2.
Position the hood so that:
a.)
The wiring is routed through the
knockout opening
b.)
The large part of the keyhole slots fit
over the hood mounting screws
3.
Adjust the hood so that the front is flush
with the cabinet frame.
4.
Tighten the hood mounting screws firmly.
5.
Fasten the wiring to the hood with the
proper electrical connector for the type of
wire being used.
WARNING: All electrical connections must be
in accordance with local codes, ordinances
or National Electrical Code. If you are
unfamiliar with the methods of installing
electrical wiring, secure the ser vices of a
qualified electrician.
Connector
Socket
Plastic lens
Star locknut
Grounding
bracket
White wires
Black wires
Ground wire
Green ground
screw
