– 66 –
'HOL3DQ7KHUPLVWRU5HSODFHPHQW
1. Unplug the refrigerator.
2. Access the deli pan thermistor (see
'HOL3DQ
&LUFXLW%RDUG
section, follow steps 1 through 6).
3. Turn the circuit board shield over to access the
thermistor.
4. Pull the thermistor out from the four tabs in the
circuit board shield.
5. Place the replacement thermistor next to the
original thermistor.
6. Cut the wiring at a location that will match the
original length when the replacement thermistor
is spliced to it.
7. Use plastic bell connectors (
3DUW
:
WR01X10466). Fill each connector with silicone
grease, then splice a new thermistor into the
harness, as shown in the illustration.
4. Simultaneously press each of the three bottom
tabs while lifting the bottom of the circuit board
shield.
5. Slide the circuit board shield out from the four
top tabs.
6. Remove the two T-15 Torx screws from the
circuit board.
7. Carefully press each of the four tabs and remove
the circuit board from the deli pan cover.
8. Disconnect the circuit board wire harness.
Deli Pan Thermistor
Tab (1 of 4)
Tab
Tab
Tab
Tab
Silicone Grease
(Continued next page)