assembly and installation
Electrical Installation
7160-9001-560
01. December 2020
1. Push the threaded cable cord grip and
connector housing over the cable.
2. Strip the cable sheath over a length of
approximately 30 mm.
30 mm
8
3. Fold the mesh shielding back over the
cable sheath.
4. Cut the mesh shielding to a length of approx. 8 mm and fasten it with the
adhesive shielding foil provided.
5. Raise the flaps
6. Arrange cores in accordance with TIA
568-B
(see connection diagram)
7. Insert the individual cores in the chambers
of the flaps.
8. Fix the cable by pressing the shielding flaps
together.
9. Cut the cores flush
10. Press the terminal blocks together. This
establishes the electrical contact.
11. Push the connector housing over the plug
insert until the latches can be felt to
engage.
Make sure the connector housing (logo
upwards) and connector plug (latch
underneath) are correctly aligned.
12. Then screw the cord grip hand-tight.
