GE WSXH208T, Technical Service Manual, Page: 31 / 51

30
panel front mounting brackets.
4. Remove screws (6) securing the control panel. Five
of the screws are located on the rear of the control
panel and one screw is on the front side, located
behind the bottom left corner of the fabric dispenser
drawer.
5. Remove indicator lamp and reed switch from con-
trol panel by prying gently with a small screwdriver,
being careful not to distort or damage control panel
securement tabs.
6. Remove the long dispenser connecting rod by
pulling gently at each end to remove.
7. Remove cam follower at timer by turning phillips
head fastener counter clockwise about 1/8 turn,
and pull to release.
8. Remove pivoting arm on dispenser by depressing
catch and pulling up on arm.
9. Remove water distributor by prying catch out
slightly with small screwdriver while lifting up.
10. To reassemble, use the triangular projections to
preload the spring before installing. Place the
spring on the rear projection then wind spring 3/4
turn and hook on small projection.
11. Next install water distributor by inserting hand into
the dispenser shell and hold water distributor in
place while pressing top portion into place. Water
distributor shaft is keyed and will only fit in one
position.
12. Release spring off front (smaller) projection to put
tension on cam follower.
13. The "a", "b", "c", notations on the dispenser hous-
ing refer to:
a = detergent chamber
b = bleach chamber
c = fabric softener chamber
The eccentric pointer should stop in the middle of
each chamber's bandwidth. If this is not possible,
center the pointer to areas "b" and "c", at the
expense of area "a" using the adjusting lever beside
center of pivoting arm.
To Remove or Replace Automatic Dispenser