
29
release.
NOTE: If the drawer front is being replaced, remem-
ber to transfer the small magnet to the new drawer
front. This magnet operates the reed switch and the
washer will not operate without it. Pry magnet out
using a small screwdriver
4. To remove the drawer latch, Slide the latch handle
all the way to the left to compress the latch spring
and pull the latch handle from the drawer front.
5. To remove or replace drawer trim, disengage trim
lower mounting tabs from drawer first, then remove
from upper slots.
To Remove or Replace Dispenser Linkage:
1. Disconnect the washer from electrical supply.
2. If dryer is stacked on washer, remove clothes dryer
from top of washer.
3. If freestanding, remove the top panel and the top
AUTOMATIC DISPENSER
The dispenser assembly provides automatic dispens-
ing of detergent, bleach, and fabric softener as long as
the user fills the compartments prior to starting the
washer.
The products added to the drawer are diluted with water
before they are dispensed into the tub. This is accom-
plished by a water distributor that sprays a controlled jet
of water into the proper compartment at the correct
time. The water distributor movement is controlled by a
cam located on the timer shaft. A cam follower "reads"
this information and transmits the movement to the
water distributor with the aid of a plastic rod and an "L"
shaped arm.
The dispenser drawer also houses a magnet that is
used to actuate a small magnetic reed switch mounted
on the console. This switch is used to stop the washer
operation if the dispenser drawer is opened more than
1 inch (approx.).
To Remove or Repair Dispenser Drawer:
1. Remove the drawer by first sliding the safety latch
to the right, then pulling the drawer out until it stops.
2. Reach back to the left rear corner of the drawer
cavity and press down firmly on the lock tab (left
rear portion of the drawer). Pull out the drawer.
3. The drawer front can be removed from the drawer by
carefully disengaging the three locking tabs to
Summary of Contents for WSXH208T
