GE Spacemaker WSM2700, Use And Care Manual

Page: 9 / 24

See the Controls Setting Guide.
Turn Cycle Selector clockwise to desired cycle
and select correct dryness level or drying time for
load type.
Press the Start button. (Opening door
during operation stops dryer. To re-start,
close door and press the Start button again.)
Operating Y
our Spacemaker Appliance
HOW TO OPERATE YOUR DRYER
WARNING—To reduce the risk of fire, electric shock, or injury to persons,
read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Timed Dry Start
Auto Dry
Delicate
LOW
HEAT
AIR FLUFF
(HEAT OFF)
OFF
MEDIUM HEAT
OFF
OFF
MORE
DRY
LESS
DRY
HIGH HEAT
DR
YN
ES
S
10
30
50
10
30
50
70
90
1
2
Set the controls
Load the dryer properly
• Load sorted clothes into dryer. See Loading section.
• Clean lint filter before each load.
Remove the lint filter by pulling
straight up. Wipe all accumulated
lint from screen. Properly reposition
lint filter after cleaning. Occasionally
wash filter using soap and warm water.
Rub lightly, rinse and dry thoroughly. This
will help remove all fabric softener buildup.
Do not use dryer-applied fabric softeners unless
you follow these lint cleaning instructions.
Do not operate dryer without lint filter in place.
• Close door. Door must be closed before dryer will
operate.
Polyester Knits & Perm Press Drying Tips
• Do not overload—Garments being dried or
dewrinkled should tumble freely.
• Remove clothes immediately—To help prevent
wrinkling, remove clothes from the dryer
immediately at the end of the drying cycles.
• Place on hangers—Permanent Press and
Polyester Knit garments look best if placed
on hangers after drying.
How Timed and Automatic Drying Differ Dryness Guide for the Automatic Cycle
Automatic drying—The Automatic Dry Control
system continually senses air temperature in dryer
drum. Wet laundry keeps this air cool. When drum air
is warm enough, heat turns off. When the air cools,
heat turns back on. This on and off cycling may
happen a number of times (depending on the fabric,
load size and Cycle Selector setting). The Cycle
Selector advances (when the heat is off) until
it automatically turns dryer off.
Timed drying—You select the number of minutes
you wish the dryer to run and it turns off at the end
of this time period.
Set to
Middle
Position
Set toward
MORE DRY
Set toward
LESS DRY
Auto Dry
OFF
MEDIUM HEAT
MORE
DRY
LESS
DRY
DR
YN
E
S
S
Auto Dry
OFF
MEDIUM HEAT
OFF
MORE
DRY
LESS
DRY
DR
YN
E
S
S
Auto Dry
OFF
MEDIUM HEAT
OFF
MORE
DRY
LESS
DRY
DR
YN
E
S
S
• For most normal loads.
• For loads that include heavyweight
fabrics.
• If you desire to remove more
moisture.
• For most normal loads.
• For very small loads. (Add two or
more similar articles, even if dry, to
assist tumbling.)
• If you desire to remove less moisture.
9
1 2