GE Profile PTWN8055MMS, Technical Service Manual

Page: 38 / 46

– 38 –
3. Remove the clutch coupler assembly.
4. Disconnect the wiring connector from the clutch
motor.
5. Remove the two 10-mm hex-head screws that
hold the clutch motor in place.
To remove the clutch shifter assembly:
1. Remove the rotor. (See
Motor Assembly .
)
2. Remove the three Phillips-head screws from the
clutch coupler plate.
Clutch Motor
Disconnect
Bearing Housing Assembly
To remove the bearing housing assembly:
1. Remove the motor assembly and clutch shifter
assembly. (See
Motor Assembly
and
Clutch Shifter
Assembly
.)
2. Remove the screw that holds the ground wire
to the bearing housing. Remove the twenty-
one 10-mm hex-head screws that attach the
bearing housing assembly and safety shield.
3. Remove the bearing housing assembly.
Ground Wire
Shield
Note :
• When installing the bearing housing, be sure the
safety shield is in place.
• Make sure the motor and Hall sensor wires are
positioned in the wiring guard and away from
the motor.