GE Profile PTWN8055MMS, Technical Service Manual

Page: 19 / 46

– 19 –
6. Carefully lift and pull the water valve assembly
out of the water distribution system inlet.
Remove
Remove
Disconnect
Note: When installing the water valve assembly,
place valve with fl anges inside the component tray
(as shown below).
Flanges
3. Note the placement of the wiring, and then
disconnect the wire harnesses from each coil.
4. Remove the 2 outlet hoses from the valve
assembly.
5. Remove the 3 Phillips-head screws that attach
the valve to the component tray.
Water Distribution System
The water distribution system consists of a multi-
function water valve, dispenser inlet, dispenser, and
bleach dispenser and jet spray outlet hoses.
Dispenser
Bleach Dispenser
Softener
Jet Spray
Cold
Hot
Dispenser
Inlet
To remove the water distribution system:
1. Remove the water valve. (See
Water Valve
.)
2. Remove the 2 Phillips-head screws from the
dispenser.
3. Push the fl ange, located near each side of the
dispenser, outward to clear the tab.
Tab
Tab
Tab
Flange
Flange
( Continued Next Page )