– 48 –
Ambient Thermistor
The ambient thermistor
is located under the right
side of the top table.
To replace the ambient thermistor:
Note:
In the following step you do not need to
disconnect both reed switch wire harnesses.
Remove the top table
1.
.
(See
Top Table
.)
Cut off the thermistor leads where they enter
2.
the thermistor body.
3. Use plastic bell connectors and
fi
ll the
connector with RTV102 silicone then splice a
new thermistor into the wires as shown in the
illustration.
RTV102
Thermistor
Cut Here
Cut Here
Over Temperature Thermostats
Fresh Food Over Temperature Thermostat
The over temperature thermostat is attached
on a bracket located on the top left side of the
evaporator. (See
Component Locator Views
.)
The thermostat wiring is attached to the evaporator
with 2 plastic wire ties and the thermostat is held
to the bracket with a metal clip. It is necessary
to remove the FF evaporator from the recess to
replace the over temperature thermostat. (See
Fresh
Food Evaporator
.)
Bracket
Metal Clip
Over Temperature
Thermostat
Left Side View of Evaporator
Freezer Over Temperature Thermostat
The over temperature thermostat is attached
on a bracket located on the top right side of the
evaporator. (See
Component Locator Views
.) The
thermostat wiring is attached to the evaporator
with a plastic wire tie and the thermostat is held to
the bracket with a metal clip.
Top Right View of Evaporator
Over Temperature
Thermostat
Bracket
Metal Clip
