– 33 –
Top Table
The top table is located on top of the refrigerator.
The top table houses 2 reed switches and covers
both door hinges, ambient sensor, wire harnesses,
and the dispenser water tubing disconnect. Two
hinge tabs position the top table over both door
hinges and 3 screws attach it to the cabinet.
To remove the top table:
Open both doors.
1.
Insert a small
fl
at blade screwdriver under each
2.
of the 2 top table caps, and carefully pry them
away from the top table.
Remove the 3 recessed Phillips-head screws
3.
that hold the top table to the cabinet.
Pull each side of the top table up to release each
4.
hinge tab.
Place the top table upsidedown on top of the
5.
cabinet and disconnect both reed switch wire
harnesses.
Cap
Top Table
Door Reed Switches and Door Magnets
The top table houses 2 reed switches, (1 for each
door). Each switch informs the main control board
the status of each door, whether it is open or closed.
Each switch is activated by a magnet recessed in
the top of each door.
Replacement table tops are supplied with the
switches installed. The switches are also available
separately.
To replace the reed switches, it is necessary to
remove the top table (See
Top Table
.) and place it
inside-up on a protective surface.
Note:
The reed switches may be lightly glued to the
top table. It will be necessary to carefully pry and
separate the switch from the glue.
Each reed switch is held in place by small tabs that
can be carefully pried back.
Tab
Tab
Reed Switch
(
Continued next page
)
