6000 & 7000 Series DISHWASHERS
PAGE 20
4.10.1.2 Models 6600 and 6605
To access the output latching mode on Rotary Models 6600, 6605 align the wash cycles and heat options indicators on the
knobs with the Start/Cancel button (both knobs horizontal and pointing towards start/cancel button, then press and hold for 3
seconds the Start/Cancel button when no program LEDs are on. Both LEDs are to turn on for 1 second to indicate that the
output test mode has been accessed.
To turn on an output, rotate the control knobs to the corresponding output to be controlled. (Refer table below). Then press the
Start/Cancel button momentarily to latch that output on. Pressing the Start/Cancel button again will turn that output off. More
than one output can be latched on at any one time.
To monitor the status of an input signal, rotate the control knobs to the corresponding input to be monitored, (Refer table
below). The WASH CYCLES LED will then indicate the status of the selected input.
(Note: To aid testing, the Water Level can
be monitored while controlling the Drain pump, Wash pump, or the Fill valve).
CONTROL KNOB POSITIONS
(Wash Cycle / Heat Option)
6600
6605
OUTPUT CONTROLLED.
INPUT MONITORED.
Pots & Pans /
Not applicable,
Turbidity Sensor.
Turbidity Sensor.
Normal
no turbidity sensor.
The WASH CYCLES LED will
illuminate when there are valid
turbidity sensor readings.
Normal Wash /
Normal Wash /
Detergent/
Rinse Aid Level Switch.
Normal
Normal
Rinse Aid Dispenser.
The WASH CYCLES LED will
illuminate when the low rinse aid reed
switch is closed.
China Crystal /
Light Wash /
Drain Pump Motor.
Water Level.
Normal
Normal
The WASH CYCLES LED will
illuminate when water is detected, and
Flash at 1Hz. when overfill is detected.
Note: Overfill can not be detected while
the drain pump is activated.
Speed Wash /
Speed Wash /
Heating Element (Calrod)
Door Thermistor.
Normal
Normal
& HEAT OPTION LED.
The WASH CYCLES LED will
illuminate when a calibration point of
113°F is reached. Open and short
circuit detection also exists.
Rinse Only /
Rinse Only /
Wash Pump.
Water Level.
Normal
Normal
The WASH CYCLES LED will
illuminate when water is detected,
and Flash at 1Hz. when overfill is
detected.
Pots & Pans /
Heavy Duty /
Drying Fan Motor.
None.
Normal & Heat Dry Normal & Heat Dry
The WASH CYCLES LED will not
illuminate.
Normal Wash /
Normal Wash /
Fill valve, (limited to 3 minutes
Water Level.
Normal & Heat Dry Normal & Heat Dry
to prevent flooding).
The WASH CYCLES LED will
illuminate when water is detected,
and Flash at 1Hz. when overfill is
detected.
The output test mode can be cancelled by, pressing and holding down the Start/Cancel button for 3 seconds, or by turning
off the power to the control.
Hold 3 seconds
